- Check fuel level before the driving test
- Ensure the registration (rego) is current
- Keep left on wide roads
- Maintain correct lane position at all times
- Increase your searching — move your head, not just your eyes
- Stay aware of what’s ahead, beside, and behind you
- Angle the vehicle correctly before turning
- Stay in your lane
- Check for bus and cycle lanes
- Enter bus/cycle lanes only where lines are dashed (about 50 metres before the turn)
- Do not cut corners
- Stay on your side of the road
- For dual-lane right turns, stay in your lane throughout the turn
- Always use turning bays
- Indicate and check your blind spot before entering
- Move fully into the bay
- Keep indicating while waiting to turn
- Do not stop unless required
- Check both sides carefully
- Approach slowly enough to give way if needed
- If you cannot see 100 metres in both directions, stop and edge forward safely
- Do not block traffic
- Merge into and out of flush medians correctly
- Always indicate and check your blind spot
- Indicate when exiting
- Look for cover vehicles to help you enter safely
- Always indicate and check blind spots
- Avoid braking hard or unnecessarily
- Use the full length of the on-ramp to build speed
- Indicate and check your blind spot
- Merge smoothly onto the motorway
- Check your left blind spot for emergency vehicles and buses
- Exit the motorway first
- Slow down after exiting — nothing sudden
- Avoid hard braking
- Check your centre mirror before slowing
- When travelling downhill, stay under the speed limit and cover the brake
- Keep left
- Drive to the road conditions
- Slow down before the corner
- Curbside parking: Indicate and check your blind spot; vehicle must be within 30 cm of the curb
- Parallel parking: Always indicate left and check mirrors and blind spots before stopping and when moving out
| | |
RSS Feed